H100I Firmware Update For Corsair
1.Corsair H100i v2 controller software providing both command line access and a GUI for. After a few minutes, a firmware download will be completed.Latest firmware update for corsair h100i | Tom's Hardware.
Again socket 2011 uses larger M4 screws and does not need the backplate. Tighten these in an X pattern to ensure the pressure is even, resulting in a good mount on the CPU.The H70 Core uses the same bracket for socket 1155, 1156, 1366, and 2011. These are for socket 2011, the shorter end screws into the metal mounting plate on the motherboard.Install all four of the standoffs as shown below.After installing and tightening down all four standoffs, the CPU cooler is ready to be installed.Next the thumb nuts are installed. Because of this the CorsairHydro Series H70, H80 and H100 CPU coolers all come with separate screws to mount on Socket 2011 boards.Included with the H80 and H100 are four standoffs that have a shorter wider end.
Again tighten these in an X pattern to ensure the pressure is even resulting in a good mount on the CPU. The M4 screws will screw right into the mounting holes on the motherboard. The H70 Core cooling unit and retention ring can then be installed on the motherboard. Then install the M4 screws through these holes.The retention ring should then be put on the H70 Core.
0 kommentar(er)
